6ES7153-2BA10-0XB0 ET 200S Module | 2 DI, 24V DC, 1x3A

Siemens 6ES7153-2BA10-0XB0 ET 200S digital input module. 2 channels, 24V DC, 3A per channel. For PROFINET/PROFIBUS distributed I/O.

Product: Siemens 6ES7 153-2BA10-0XB0 Digital Input Module

The Siemens 6ES7 153-2BA10-0XB0 (commonly written as 6ES7153-2BA10-0XB0) is a 2-channel digital input module for the SIMATIC ET 200S distributed I/O system. It is designed to read 24V DC signals from sensors and switches in industrial environments.

Key Features

• High-Density Input:​ Two digital inputs in a single, compact module.

• High Switching Capacity:​ Up to 3A per channel for direct connection of high-current loads (e.g., solenoid valves, indicators).

• Diagnostics:​ Channel-wise diagnostics (e.g., short-circuit, wire break) via the backplane bus.

• Modular Design:​ Hot-pluggable for easy maintenance and system expansion.

Technical Specifications

• Order Number:​ 6ES7 153-2BA10-0XB0

• Product Family:​ SIMATIC ET 200S

• Module Type:​ Digital Input, 2 Channels

• Rated Input Voltage:​ 24 V DC

• Nominal Current per Channel:​ 3 A (for signal evaluation of contacts/2-wire sensors)

• Input Delay:​ Typically 3 ms

• Electrical Isolation:​ Between channels and backplane bus

• Connection System:​ Via SIMATIC ET 200S terminal module (TM), e.g., TM-E15S24-A1

• Required Terminal Module:​ 1x 3-terminal (1x 3A) terminal module

• Backplane Bus Connection:​ Via PM-E or IM interface module

• Diagnostic Functions:​ Yes, per channel

• Protocol:​ PROFIBUS DP or PROFINET IO (determined by the installed Interface Module (IM))

• Width:​ 15 mm

• Module Code:​ 0XB0 (Internal Siemens hardware revision/identifier)

Function

This module reads binary (ON/OFF) 24V DC signals. It is suitable for connecting components like pushbuttons, limit switches, and proximity sensors that require a high switching capacity. Each channel can sink up to 3A, allowing it to directly power small actuators without an intermediate relay.

Typical Applications

Used within the ET 200S distributed I/O system for:

• Reading high-current control signals

• Direct connection of 24V DC actuators

• Distributed control cabinets in manufacturing and process plants

Important Note

This is only the electronic module (EM). It must​ be installed on a matching ET 200S terminal module (TM) and powered by a system power module (PM) within an ET 200S station, which is controlled by an interface module (IM) for PROFIBUS or PROFINET. Verify compatibility with your existing ET 200S configuration.

Note: Specifications are for product identification and comparison. For full technical data, wiring diagrams, and system configuration, consult the official Siemens manual for the ET 200S system.

More Products

Pepperl Fuchs Safety Barrier

Allen Bradley PLC Controllers

SICK Instruments 

Festo Cylinder 

IFM Sensors